Wuxi Wondery Industry Equipment Co., Ltd
Advantages: More than 10 years experience in industrial equipment; Advanced processing equipment and technology; Full technical support for pre-sales and after-sales; A team of senior engineers for
Add to Cart
Electric and Gas Aluminium Radiator Brazing Furnace 4M + 6 M
Introduction
The aluminium radiator brazing furnace is used to braze aluminum heat exchangers such as radiators, intercoolers, evaporators,
and heater radiator under protective nitrogen atmosphere. The flux used is NOCOLOK flux.
Equipment Composition
The CAB aluminum radiator brazing furnace is comprised of the following parts:
| Round Shape Fluxing system, 1 set |
| flux mixing and supply device 1 set |
| drying oven 1 set |
| front curtain chamber 1 set |
| preheating oven 1 set |
| brazing oven 1 set |
| slag cleaning chamber 1 set |
| air cooling chamber 1 set |
| rear curtain chamber 1 set |
| air cooling chamber 1 set |
| Driving device 3 sets |
| electrical control system 1 set |
| water and nitrogen piping system 1 set |
Parameters of Aluminum Radiator Brazing Furnace Line
| Mesh belt operation surface height (to the ground) | 900mm |
| Mesh belt speed | 200～1000mm/min (inverter frequency conversion); |
| Effective working size | 1200mm (wide)×250mm(height above mesh belt) |
| Brazing oven effective working size | 7000mm (L)×1200mm (W)×250mm (H); |
| Preheating oven effective size | 4000mm (L)×1200mm(W)×250mm(H) |
|
Brazing oven effective size | 6000mm(L)×1200mm(W)×250mm(H) |
| Total production line length | 36.7M |
| Total power | Electric power: 270KW Full power at temperature rising up, 60% at the brazing stage; ≤60% |
| Gas consumption | Max 66M3/H; about 52m3/h at operation; |
| 99.999% nitrogen supply | 200m3/h (actual consumption: 90-120m3/h) |
Our company mainly supplies the radiator making machines such as aluminium radiator brazing furnace (or called as CAB furnace), aluminum fin machine, core builder, radiator plastic tank crimping machine, air leak tester, header mold, plastic tank mold, etc.
Equipment Flow
The aluminum parts fitted with fixtures are manually placed at the entrance and transmitted by the chain rod to pass through spray chamber, air blowing, drying oven, front curtain chamber (nitrogen gas inlet), preheating oven, brazing oven (nitrogen gas inlt), slag cleaning chamber (nitrogen gas preheating), dry cooling chamber, rear curtain chamber (nitrogen gas inlet), and finally air blast chamber. The parts are loaded manually. The aluminium radiator brazing furnace is designed with a manual coating operation area (1.5M long) after the fluxing chamber.
